8
2.1.4 Move the radio mounting bracket to the vertical position, install RAD1 first and
connect one side of the retransmit cable (see Figure 2-3).
Figure 2-3 RAD1 installed with retransmission cable connected
2.1.5 Install RAD2 and connect the other end of the retransmission cable (see Figure 2-4.
Figure 2-4 RAD1 and RAD2 Mounted with Retransmission Cable Installed
2.1.6 Move the radio support brackets to the appropriate position for the radio being used
(see Figure 2-4 and Figure 2-5, brackets should cover the radio type label for the radio
being used). Note: Moving the side brackets requires a 3/32 Allen wrench.
Figure 2-5 AN/PRC-148 Bracket Position
.
(When 148 option is requested at time of
purchase)
Figure 2-6 AN/PRC-152 Bracket Position
RAD1 installed in vertical
position and retransmission
cable connected
Radio Support Brackets in
AN/PRC-148 position
Radio Support Brackets in
AN/PRC-152 position
Содержание TCR-HHR-02
Страница 17: ...11 DC POWER CONTROL RAD1 RAD2 Figure 2 10 TCR HHR 02 Repeater System Signal Flow Block Diagram ...
Страница 18: ...12 PELICAN CASE ENCLOSURE Figure 2 11 TCR HHR 02 Communications System Signal Flow Block Diagram ...
Страница 19: ...13 50 TX Antenna RX Antenna Figure 2 12 Typical Tactical Repeater Setup ...