Tribe EZ-Pilot Farmall 105C, Руководство по установке

Страница: 33 / 74

EZ-PILOT STEERING SYSTEM INSTALLATION INSTRUCTIONS
2 – EZ-Pilot System Installation
33
Installing the SAM-200 EZ-Pilot drive motor
Step 1
Apply a very small amount of anti-seize
lubricant to the steering shaft, splines and
taper.
Step 2
C
CAUTION – Do not force the spline
adapter onto the steering shaft. If the
splines do not mate together,
stop and
recheck that the spline teeth are aligned
and that you have the correct lower
adapter for your machine
Set the SAM-200 motor assembly onto the
steering shaft with the motor’s electrical
connector at the 5:00 or 8:00 o’clock position.
Align the spline teeth of the steering shaft and
lower adapter by hand.
Gently push downward on the motor or lightly
tap the motor's rotor (the circular ring with 6
threaded holes) with a rubber dead blow
hammer to begin mating the spline teeth
together.
When the hex nut is installed and tightened,
the motor's spline adapter will slide downward
and seat onto the steering shaft.