Installation
20
- 20 -20
The following settings are used only in search mode
Transponder
.
4.
Frequency:
For entering the frequency of the desired transponder please select line
Frequency
. Then
press
OK
and use the numeric input buttons
1…0
for entering the 5 digit frequency.
Confirm your inputs by
OK
.
5.
Polarisation:
In menu item
Polarisation
you can set the polarisation (vertical or horizontal) of the
desired transponder by using ◄ or ►.
6.
Symbol rate:
For entering the symbol rate of the desired transponder please select line
Symbol rate
.
Then press
OK
and use the numeric input buttons
1…0
for entering the 5 digit symbol
rate. Confirm your inputs by
OK
.
For starting the Channel search please navigate to line
Start scan (keys
) and press the
OK
button on your remote control.
Now a new menu is displayed with two lists displaying the founded TV and RADIO channels.
Thereby the „Status:“ graphic keeps you informed on the progression of the channel search:
- Status
scan
=> search algorithm is active
- Status
end
=> search algorithm is finished
You can leave this menu by pressing
EXIT
. If not finished, the channel search algorithm is
aborted. If new channels are found, you are asked to store them (
Yes
). Select your choice by
◄/► and confirm with
OK
. If selected YES the new channels are stored at the end of the
channel list now.
Installation
– Factory reset
This menu item allows you to reset the receiver to its default factory status. Afterwards the
receiver starts up with the Welcome Screen (initial installation) again.