12
TRI TOOL INC.
92-0660 : Rev. 080423
Rotate the hinge bracket back up and let the eyebolt drop back into the slot.
Rotate the check nut on the eyebolt to secure in the slot.
MACHINING INSTRUCTIONS
Turn the motor on to full speed by depressing the lever.
The motor should be at the low speed setting to 1.00” to 2.00” (25.4 mm to 50.8 mm)
diameter tube or at the high speed setting for .25” to 1.00” (6.4 mm to 25.4 mm)
tube.
Engage the feed by pushing the tripper shaft in.
Monitor the cutting operation and apply cutting fluid as necessary.
The machine operation is finished when the tool holder returns home, release the
lever in order to turn off the motor.
Loosen the Collet by rotating the handle up.
Remove the pipe or tubing from the Model 572AC.
The tool holder will retract automatically in 5 to 10 revolutions.
There is an audible ‘snap’ when the tool holder returns to the home position.
