TRI tool BEVELMASTER 216B, Руководство по эксплуатации

Страница: 28 / 53

26
TRI TOOL INC.
92-1783 Orig. 161006
Problem: Tool Bit Chatters
The tool bit is loose or overextended.
The tool bit is damaged.
The tool holder is too loose in the slides.
The cutting speed is too fast.
The clamping pads are loose on the pipe or tube.
Cutting fluid is required.
The front bushing pre-load is loose.
Problem: excessive Tool Bit Wear
The pipe or tube material is too hard or abrasive.
The cutting speed is too fast.
Cutting fluid is required.
A dull Tool Bit is causing surface hardening conditions (Stainless pipe or tubing).
There is scale or other foreign matter on the pipe or tube, which is dulling the tool
bit at the start of the cut.
The tool bit is incorrect for the material being cut.
Problem: Rough surface finish
The tool bit is dull, chipped, etc.
Metal build-up on the cutting edge of the tool bit is creating a false cutting edge.
Cutting fluid is required.
The cutting speed is incorrect.
Problem: The Tool Holder is Not feeding
The Tool Module nut is too tight.
Problem: Loss of Air Power
The air supply pressure is too low.
The air filter is plugged.
The air line size is insufficient.
The air line is too long.
11. TROUBLesHOOTINg