- 22 -
Tri-Tech
Medical Inc.
Alarm Installation
Labeling the Alarm Front
After all remote signal (master) wires have
been landed, identified & cataloged (using
appendix C in this manual), you are ready to
apply the remote signal labels. Remove by
unthreading the two nylon nuts shown here
from the back of the alarm front panel.
The panel will now lift out of the black frame.
Provided in the packaging with the alarm front
panel is a long white card and a pre-printed
sheet of labels for the remote alarm signals.
Wash your hands before handling these
labels and cards!
Apply the labels to the
appropriate position on the card using the guide
lines on the card. When complete, insert the
card into the “Monitored Signals” label pocket -
between the stainless steel plate and the front of
the “Monitored Signals” label.
The gas modules are shipped pre-labeled from the
factory. If a gas service is changed to a different
gas or added to the alarm, it will be necessary to
insert the appropriate label in the pocket of the
gas module. The new gas label supplied by Tri-
Tech Medical will slide into the gas module label
pocket between the stainless steel plate and the
front of the gas module label.
When the labeling is completed, install the
stainless plate into the black frame and re-attach
with the two nylon nuts.
