16
INSTALLATION AND ASSEMBLY
The assembly and installation must be done by following a few instructions.
-
The appliance must be placed high enough to be out of the reach of children (at least 200cm from the floor).
-
The appliance must be placed at a minimum distance of 50 cm from the sidewalls.
-
Do not mount on a vibrating surface. Do not install in rooms smaller than 4m
2
.
-
Make sure that the ventilation holes are not obstructed, even partially.
CAUTION! The plugs and screws supplied are only suitable for mounting on masonry walls. If you
decide to install the unit on another type of wall (plasterboard or
other), buy appropriate anchors.
-
By using a yardstick, measure the distance between the two back shapes
on back of unit (325 mm).
-
Take the product and place it on the wall in the desired location. Mark on
the wall the positions corresponding to the two back-shapes. Check that
the marks are aligned at 325 mm from each other. Drill two holes
(diameter 6mm) in the wall and insert the dowels into the holes.
-
Use a screwdriver to insert the screws into the anchors and tighten to lock
the pieces themselves, leaving the screws about 1 inch off the wall.
-
Set the product to the wall by inserting screws inside the shapes.
-
Once the screws are inserted, move the unit to the right until it locks in position firmly.
CLEANING
Unplug the power cord from the electrical outlet and allow the unit to cool down before cleaning.
-
Do not immerse the unit in water. Regularly clean the ventilation slot (7) on the back of the unit and the air
outlet grille (1) to prevent the dirt from clogging the airflow.
-
Do not clean the unit with a sponge or abrasive detergents.
TECHNICAL FEATURES
•
Power supply: AC 230V
~
50-60Hz, power: 2000W
•
Ceramic Heating elements
•
Wall-mounting, IP23 protection
•
Digital display, Remote control
•
Safety device against overheating
Содержание G3 FERRARI TEPOR
Страница 18: ...17...