8
press the MUTE button (19) again.
Note:
-
Some audio outputs which you connect the Sound Bar (like headphone output) can
HAVE
its own
VOLUME
control: make sure you
HAVE
set on the source
DEVICE
an adequate
LEVEL
audio output otherwise the Sound
Bar will sound
EVEN
at maximum
VOLUME
.
-
If the sound played by the Sound Bar be distorted means that the input signal is too strong: lower the
VOLUME
of the Sound Bar or paid on a
LEVEL
audio source
DEVICE
output more low.
-
In case of connection to a TV by headphone output, it may happen that the sound reproduced by the Soundbar
is low
EVEN
at maximum
VOLUME
; in this case try connecting the Soundbar to the audio-scart output using
an adapter (not supplied).
USB/SD CARD (TF CARD) INPUT
1.
Insert a USB memory into the input (5) or an SD card into the input (6);
2.
Turn ON the nit, it will automatically play the Music file inside the USB or SD Card;
3.
Press
(15) button on the remote control to momentarily stop playback. Press it again to resume playback;
4.
Press
(16) or
(14) button on the remote control to select tracks.
AUX-IN
1.
Plug in 3.5mm AUX cable;
2.
Turn ON the unit, press (13) button on the remote control and select the AUX-IN input;
3.
For proper playback sound refer to chapter VOLUME ADJUSTMENT AND MUTE FUNCTION.
OPTICAL INPUT
1.
To use a digital optical cable (not included) to connect the OPTICAL input (8) to the digital optical output of your
TV or other source devices;
2.
Turn ON the unit, press (13) button on remote control and select the OPTICAL input;
3.
Adjust the volume using (18) Vol+ and (20) Vol- buttons.
Note:
-
Some TVs or
DEVICES
is necessary to enable the digital optical output.
-
PCM digital audio must be set on the source
DEVICE
for playback from this input.
BLUETOOTH OPERATION
1.
Turn on the unit; press (13) button on remote control to select the BLUETOOTH function;
2.
The system automatically goes into search mode, if not press, for a few seconds, the UNPAIR button (21) on
remote control;
3.
Activate the Bluetooth functionality on the external device to be paired;
4.
Start the device search. At the end select the "SB 8340 SW" device;
5.
Enter the password "0000" if required;
6.
Press
(15) button on remote control to start playback and the
(16) or
b14) button on remote control
to select tracks;
7.
Press and hold for a few seconds UNPAIR (21) button on remote control to stop the active connection and pair
a new device.
EQUALIZER
The soundbar has a pre-set equalizer system, repeatedly press the EQ button (17) during playback to select the audio
dynamic that best suits the music style being played.
ENGLISH
SB 8340 SW