Troubleshooting
Windows doesn't recognize my new hardware. What should I do?
erify that your computer meets the system requirements as specified in
Section 1
.
2. Go to
Start -> Control Panel -> System > Hardware ->
Device Manager
. In the list of device types, double-click on
Network
Adapters
. If you see the device with a yellow question mark or exclamation
point next to it, double-click on it, click on
Drivers
and click
Update Drivers
.
3. If the device manager fails to recognize the presence of a new networking
adapter, verify that the network adapter is firmly seated in the PCIE Slot.
Windows recognizes my new hardware, but I'm unable to connect to my network.
What should I do?
Verify that the cable is securely connected from your switch or router to
your network adapter.
2. Verify that the LEDs on your network card are lit. Third, verify that the TCP/IP
settings are set to
Obtain an IP address automatically
.
Why am I only getting a network connection speed of 100Mbps instead of
1000Mbps for the TEG-ECTX?
1. Check the Ethernet Cable. Make sure you are using CAT-5e or CAT-6 E
thernet Cables. Some CAT-5 cables are not rated to run in Gigabit.
2. Make sure you are connected to a 1000Mbps switch.
I am not getting a network connection when I connect the TEG-ECSX to my
network. What should I do?
1. Check the fiber cable. Make sure you are using
50/125ìm or
62.5/125ìm multi-
mode fiber cable.
2. M
ake sure that the opposing connection is Gigabit multi-mode
fiber connection.
The TEG-ECSX will not auto negotiate to 10 or 100Mbps.
What is the maximum distance that is supported by the adapters?
TEG-ECTX: 100 Meters. TEG-ECSX: 550 meters.
If you still encounter problems or have any questions regarding the
TEG-ECTX/TEG-
ECSX,
please contact TRENDnet's Technical Support Department.
1. V
1.
4
