TREND Lock Jig A, Руководство пользователя

Страница: 11 / 19

LOCK/JIG/A
-10- -10-
Fitting the Guide Bush
Fitting Guide Bush to
T10/T11 Router
■
If using the Trend T10/T11 Router, fit a 30mm
guide bush Ref GB30. Make sure the bush is
correctly centred.
If there is any doubt about the
concentricity of cutter relevant to
the guide bush, then a sub-base
should be used in order to ensure an
accurate fit of face-plate.
Ensure guide bush collar is fitted fully
onto the guide bush with chamfer
facing the jig.
Fitting Guide Bush to T5 Router
■
If using the Trend T5 Router, purchase and fit
a GB30.
■
If using the Hinge Jig, fit the GB160 supplied
with the Hinge Jig. By using the Guide Bush
Collar supplied with the Lock Jig, the same
router set-up can be used by simply fitting
the collar in between the hinge and lock
operations.
■
The guide bush collar can be stored on the
spigot fixed to the outside of the clamp bar
when not in use.
Ref. GB160
Ref. GB30
Ref. GB30
Guide bush
collar
Make sure guide bush
collar is fitted with
chamfered edge facing
the jig when parked.
This will make it easier
to remove.
Frequently check that the guide bush
collar is seated properly on the guide
bush. Check that the collar has not
worked loose otherwise this will
affect the cut.