Trejon 431003, Инструкция по эксплуатации и техническому обслуживанию

Страница: 21 / 36

Instructions for Use and Maintenance 151H
– 191H (1808)
21
Breddningsving
en monteras
på insidan av
maskinen
3.5 Operating the machine
Warning!
Operator must have a good view over the working area and the area where the ejected
snow lands. Heavy items in the snow, such as stones etc., can be propelled much
further than the snow itself.
Before leaving tractors cabin ensure that all moving parts have come to a complete
stop.
Caution!
The shear bolt is No guarantee for machine not being damaged at impact with heavy,
solid objects.
To avoid damages on machine, lift snow blower before going backwards with the
equipment.
A doubled driving speed, make the stress at the equipment four times higher. Damages
on snow blower caused by impact with heavy, solid objects isn’t covered by the
warranty.
The temperature of the hydraulic oil must not exceed 75 degrees during operation of
the implement.
Place the snow blower on the surface which is to be cleared. Start the snow blower by slowly
releasing the oil flow while the tractor’s engine is at idle speed
. Change to a higher gear.
If you want to turn off the snow blower, perform the above procedure in reverse order. 1.
Change to idle speed, 2. Stop the oil flow to the machine.
We advise you against using this equipment as a plough. Always let the equipment work its
way through the snow with the cutter turning. When clearing great masses of snow you should
work yourself through in two runs.
When operating in wet and heavy snow, more power is needed, and the equipment needs to
be used with high revs before working on the snow. If you should come to a halt, stop the
tractor, lift up the equipment, back up a bit, let the equipment down, and try again. Should
there be an obstruction in the ejector tube, the tractor and the oil flow must be stopped before
the equipment is cleaned. Inform anybody in the vicinity that work is going on with the
equipment. Drop the ejector tube and clear the obstruction.
When using the equipment for the first time in the cold season, you should set it to lean back a
little. This will ensure that the wearing edge does not pick up a lot of stones and debris that
can be ejected dangerously. After a while as the road has become hard, you can set the
equipment to a more aggressive angle.