treesse FUSION SPA, Руководство по эксплуатации и техническому обслуживанию

Страница: 18 / 40

18
EN
Fusion Spa
minipool
Use
SPECIAL FUNCTIONS
BACKWASHING
3 seconds
10 seconds
Water filtration takes place through a sand filter connected to
the recirculation pump.
Cleaning the sand filter is essential because it retains polluting
materials like hair or leaves and sediment if the minipool is
installed outdoors.
The best cleaning is achieved with a
backwash
, i.e., with a
jet of clean water from the bottom of the filter so that the dirt
can flow into the drain.
The cycle lasts 20 minutes.
In Treesse minipools backwashing is
automatic
, running
automatically every 48 hours of minipool use, but can be
forced
manually
by pressing:
the key for about
10
seconds
backwashing in progress is indicated by the
LED
t he key for about
three
seconds
backwashing in progress is indicated by the
appearance of the word "FLT" on the display
Backwashing disables:
• The recirculation pump
• The heater
• The ozonator
A backwash cycle can be interrupted only by turning off the
power switch of the minipool.
It is recommended to change the sand
every year
(see page 30).
HEATER
OZONATOR
Automatic functions
Heater
The heater is automatically activated when the water
temperature in the minipool is one degree lower than the
value set with the control panel.
If not already active, the recirculation pump is automatically
activated.
if the heater is operating the LED
is active
if the heater is in operation, a dot flashes
on the bottom right of the display
Ozonator
The ozonator is activated by the circulation pump and turns
off automatically during the WHIRLPOOL function.
When the ozonator is operating the LED is active (white
keypad).