12
Rev 2, 1_19_2016
UNIT KEY is used to toggle between different weighing units.
Clearing tare weight
Place an empty container on the platter. Press the TARE key. The WEIGHT
display shows 0.000.
When the container is removed from the platter, the WEIGHT display will show a minus
(-) value which is the weight of the container
Clearing previous tare value
Remove the weight from the platter then press the TARE key so that the TARE indicator
will turn off and the WEIGHT display returns to Zero.
Weighing procedures
Whenever possible, before weighing, please allow the weighing machine to warm up
for at least 10 minutes after turning it on. This will help to ensure optimal functioning
and operation.
Press the ON/OFF key to turn on the weighing machine. The display will show all
segments for a few seconds and then the “0” will appear.
Press the UNIT key to select the desired weighing unit
– “kg”, “g”, “lb”, “oz”, “lb:oz”.
To begin weighing, place the objects to be weighed in a weighing container
or directly on the platter.
The stable indicator will display when the reading becomes stable.
Calibration
Note:
Calibration is done in the factory. Don’t re-calibrate the machine unless
it is not
accurate. The weighing machine should be allowed to warm up for at least 10 minutes
before calibration.
Before entering calibration mode, press the ON/OFF key to turn the power on
for 1 minute.
Next press the ON/OFF key again to turn the power off.
Press and hold the UNIT key and then press the ON/OFF key. The display will
show “CALu=”.
Press the UNIT key to select the calibration weight units ( g, lb, etc). Press the
ZERO key to select the calibration weight. The display will show xxxxx. The X
will be flashing. Press the UNIT key to move the flashing digit to the right. Press
the TARE key to increase the flashing digit.
