Treasure Cove TC1X, Руководство по эксплуатации

Страница: 16 / 24

13
Let's Find Something
So you have spent some time getting familiar with your new Treasure Commander TC1X
detector and are ready to head out and see what you can discover. Let's get started!
1. Extend the rods to the desired length. The detector should be resting on the
ground about 2-3 feet in front of you.
2. Turn the TC1X on by pressing the
POWER
touchpad
3. Press the
SETTINGS / DEL
touchpad and adjust the
SENSITIVITY
and
VOLUME
to the desired values which will be dependent on site conditions and personal
preferences. Once the adjustments have been made, press
ENTER
to save them.
4. Press the
SETTINGS / DEL
touchpad again and select either
DISCRIMINATION
or
NOTCH
. Select the option desired and press
ENTER
. Make the selection using
the "
< / PP
" and "
> / DIS
" touchpads to determine what segments will be
accepted or rejected. Once you have made your changes, press
ENTER
to save
them.
5. Press the
GG
touchpad to enable the detector to determine the ground
mineralization present and calibrate the circuitry to provide maximum performance.
Press the
ENTER touchpad and follow the on-screen prompts until you receive the
message " GRAB OK " which indicates the calibration was successful.
6. Sweep the coil over the ground in a side-to-side motion. The optimum sweep
speed is 3 to 5 seconds per pass (left-to-right or right-to-left). Remember, it is not
a race to see how quickly you can cover an area but rather how thoroughly you
cover the area to ensure you have not overlooked any valuables. Most good
targets will produce a clear, repeatable signal. Trash targets (those that are being
rejected) generally do not produce a signal or will only give a broken or non-
repeatable response. Experience will tell you when to investigate those marginal
signals but initially, focus on repeatable signals that produce consistent indications
on the LCD screen.
7. When a target has been detected, move the coil off to one side and press and hold
the "
PP
" touchpad. Move the coil over the area where the
target is buried in an “X” shaped pattern .
Observe the Target Depth indication and listen to the audio
response. When the indicated depth is the shallowest and
the audio volume is the loudest, the target should be directly
beneath the center of the search coil.
8. Carefully recover the target and be sure to replace the soil / grass before moving
on to the next target.