8
•
Revo 3.3
THE TRAXXAS TQ 2.4GHZ RADIO SYSTEM
REVO WIRING DIAGRAM
TQ 2.4GHZ TRANSMITTER
Antenna
Steering
Trim
Throttle
Trim
Throttle
Trigger
Shift
Switch
Throttle Neutral
Adjust
Steering Wheel
Power
Switch
Battery
Compartment
Servo Reversing
Switch
Set Button
Channel 3
Trim
Status
LED
Power Indicator
Applying The Decals
The main decals for your
model have been applied at
the factory. The decals are
printed on self-adhesive clear
mylar and are die-cut for easy
removal. Use a hobby knife
to lift the corner of a decal
and lift it from the backing.
To apply the decals, place one
end down, hold the other end
up, and gradually smooth the
decal down with your finger
as you go. This will prevent air
bubbles. Placing both ends
of the decal down and then
trying to smooth it out will
result in air pockets.
Antenna
On/Off
Switch
Receiver
RX Power Pack
5-cell NiMH
Battery
Steering
Servos
Throttle Servo
Shifting Servo
(micro servo)
OptiDrive ESM
(Electronic Shift
Module)
Charging Jack
(to charger)
To Transmission
(OptiDrive sensor)
Your Revo is equipped with the TQ 2.4GHz radio system. The TQ 2.4GHz is a 3-channel system that provides control for up to three outputs. Revo is equipped with two high-
torque steering servos connected via dual Channel 1 outputs. The TQ 2.4GHz works in conjunction with the OptiDrive
®
Electronic Shift Module to monitor and control the
input and output signals for the throttle and shifting servos (channels). The OptiDrive monitors the voltage of the on-board RX Power Pack. The “Function” LED will flash red if
the battery voltage is too low. The 2.4GHz 4-channel receiver is also equipped with low-voltage detection and will enter fail-safe mode if battery voltage drops too low.
