Flash Exposure Compensation
You can use the exposure compensation function of the camera to compensate flash output so as to
make shooting effect better meet your requirements .You can also make compensation of flash
brightness with the (LEFT)(RIGHT) button within the range of +-6ev ,,with the precision of 1/3ev.
Every press the button,the compensation setting will be displayed on LCD panel .
Rear curtain Sync
You can use slow-speed shutter to produce trailing smear for the object and the flash light will flash
at the moment when the shutter is going to be shut, which means the rear-curtain sync function .
(For the rear curtain sync setting ,refer to your camera manual for setting).You can turn on or turn
off the rear curtain sync by pressing the rear curtain sync hotkey on panel of flash.
Note :when flash is used as slave unit ,the rear curtain sync function can not be set on the speedlite.
Exposure Bracketing FEB
The FEB function is set on the camera or speedlite.For the specific setting method ,refer to your
camera instructions .After the FEB is set ,after 3 photos are taken ,exposure compensation will
be made automatically in the sequence of ,for example ,“normal-under-over”.This function helps
you improve the success rate of photo taking .
The setting method on the flash :press the (UP)(DOWN) button to adjust the exposure bracketing
amount .
Note :For FEB,set the camera's drive mode to single shooting.Be sure the flash is ready before shooting.
Creating a Catchlight
With the catchlight panel, you can create a catchlight in the subject's eyes to add life to the facial
expression.
Wide-angle diffusion board
Pull out the wide-angle diffusion board, push back the reflection board and arrange them as per the
figure ,the flash scopes will extent and the flash effect will be softer and more natural.
Pull
out
the
wide
-
angle
diffusion
board
Push
back
the
wide
-
angle
diffusion
board
FEL Lock(Canon )
To use this function, cover the subject, for which flash exposure will be locked at the center of the
viewfinder of camera, press the button (*)of the flash exposure lock, and the flash light will pre-flash
and the camera will calculate the appropriate flash output data .Now you have some time for
decomposition ,after which ,you can take photo.(The function can be used only when it is supported
by your camera. For the setting method ,refer to your camera instructions.)
-
24
-
-
25
-
E
N
E
N
