Page 27
INSERT OPTIONAL EQUIPMENT (Continued)
3. Flush Kit
The flush kit is used to extend the surround panels towards the front of the insert, making the insert extend
much less onto the hearth. The flush kit must be used in conjunction with one of the surround panel sizes
listed in this manual. Follow the directions below to install the flush kit.
1.
Remove the three button plugs from each side of the insert with a screwdriver . See the illustration
below.
2.
Using a 5/16" nutdriver or large screwdriver, screw the thread-cutting screws into the three holes on
each side extender. Next, screw the thread-cutting screws into the two holes in the flange on top of
the insert. The holes are now pre-threaded, remove the screws.
3.
Attach one of the side extenders with three screws against the side of the insert so the three tabs on
the extender go inside the panel on the side of the insert. Repeat for the other side.
4.
Line up the two holes on the top extender with the two holes on the top flange of the insert. Attach the
top extender with two screws.
5.
Included with the flush kit is a bypass damper rod extension. Unscrew the bypass damper rod pull
ring and install the rod extension. Replace the pull ring on the end of the extension.
6.
The flush kit is now installed. When installing the surround panels, refer to the section on installing
the surround panels, substituting two steps:
(a) attach the side panels to the extenders, not to the insert;
(b) attach the top surround panel to the top extender, not to the flange on top of the insert.
Remove all three button
plugs on both sides.
Attach
the side
extender
with
three
screws
using a
5/16"
nutdriver.
The damper rod must
be unscrewed here and
the damper rod
extension put in place.
These holes are for
the screws that hold
the top extender in
place.
The top extender connects to
the insert with two screws.
Attach the side surround panels through these holes.
The top surround
panel slides over this
flange.
Pre-thread
the three
holes
before
installing.
THE THREE
TABS FIT
BEHIND THE
PANEL ON
THE SIDE OF
THE INSERT.
