Travis Industries 99200149, Инструкция по эксплуатации

Страница: 5 / 8

ZC Kit – Large Pellet Insert
(99200149)
Page 5 of 8 10/9/06 © Travis Industries, Inc.
Minimum Floor Protection
•
The insert must be placed on a non-combustible floor protector (cement board, sheet metal, etc.) a
minimum .018” thick (26 gauge). This floor protection must extend the full width and depth of the
enclosure and must protrude 6” in front of the door opening (18” from the enclosure opening) and the full
width of the surround panels (45” min. width).
•
HEARTH NOTE: If you wish to install a hearth greater than 1/2” thick, you will need to raise the insert and
enclosure height the equivalent amount. The leveling bolts may be used on the insert for adjustments.
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
AAAAAAAAAAAA
45” Min.
(width of surround panels)
18” Min.
Floor Protection
AA AA
AA
AA
AAAAA A
A
A
A
A
A
A
AAAAAAAAA A
A
A
A
A
A
A
Enclosure Height
(measure from top of
floor protection)
AAAAA AAAA AA AAA
AA
AA
AA
Floor Protection
Rear Vent Installations
Place the stove on top of the floor protection and measure the center of the
flue. This will determine the location of the wall thimble.
12”
Minimum
A