28
Operation
© Travis Industries
5/20/2021 - 1558
430 MF GSR2
Before You Begin
Read this entire manual before you use your new heater (especially the section "Safety Precautions"
on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or
even death.
Remote Control Warnings
KEEP BATTERIES INSTALLED AT ALL TIMES
The remote control system requires the batteries to remain in place at all times. Once
the batteries are removed, the system may re-start in standing pilot mode. If this occurs
when the heater is in Remote Mode, you will not be able to turn the heater off manually
from the battery box.
If you need to replace dead batteries, make sure to
turn the appliance off
before
removing the batteries.
NOTE
: If the batteries go dead, the system will operate normally as long as
household power (120v AC) is present.
The transmitter and IFC are radio frequency devices. Placing the transmitter in or near metal may
severely reduce the signal range.
Turn off the main gas supply to the appliance during installation or maintenance. In case of remote
control malfunction turn off the main gas supply to the appliance.
PROGRAMMING THE REMOTE
The SIT GSR2 remote may be programmed to disable the thermostat or any of the modes (flame height, blower,
light, comfort control, Standing Pilot *, or auxiliary power input). This allows you to tailor the remote to the appliance.
* We do not recommend disabling the standing pilot option for our gas appliances. This feature may be
recommended for cold regions or installations with sub-optimal venting.
How to Disable/Enable the Thermostat
The remote is shipped with the thermostat enabled.
1
Remove one battery from the remote.
2
Press and hold the thermostat button while
replacing the battery. This will toggle the
thermostat function. Repeat this process to toggle
the thermostat function to the desired setting.
How to Disable/Enable Modes (Light, Blower, etc.)
The remote is shipped with all modes enabled.
1
Remove one battery from the remote.
2
Press and hold the on/off button and mode button while replacing the battery.
Keep the on/off button depressed during the following steps.
3
While keeping the on/off button depressed, press
and release the mode button until the mode that
needs to be changed is illuminated.
4
With the desired mode illuminated (see illustration
to the right), press the “up” or “down” button to
activate or clear the mode being addressed.
Make sure to keep the on/off button depressed
during this process.
5
Release the on/off button to complete
programming.
