8
For answers to your questions, call 1-877-339-7505
Battery Installation
a.
Place the battery into the Velcro-lined battery tray between the rear wheels of the scooter with the battery plug facing the
rear-left wheel.
b.
Connect the battery plug to the corresponding plug on the TravelScoot motor.
c.
Secure the battery with the two Velcro straps. The ends are to remain loose.
Seat Assembly
It is recommended that you keep the seat post inserted in the yoke as far as possible while still at a comfortable height. The higher
the seat is mounted, the more your C.G. will be affected. When adjusting the seat height, do not raise the seat higher than 2.5 inches
or the combined height of the seat spacers. To assemble the seat:
a.
With the lever clamp(s) open, insert the yoke into the receptacles next to the battery tray.
b.
Note that one stem of the yoke is narrower. This stem can only fit into the right receptacle.
c.
Insert both stems fully into the two receptacles at the same time and push firmly into place.
d.
Once yoke is in place, tighten the lever clamp(s).
e.
Install the seat in the top of the yoke and tighten the seat clamp.
f.
Insert the backrest elbow into the back of the seat, depress the spring lock, and slide in place until the spring lock is
through to the other side. It may be easier to perform this step before installing the seat.
g.
The lever clamps may need to be adjusted from time to time to hold the seat and the yoke in place. Test to make sure the
seat is secure in the yoke and that the yoke is secure in the receptacles (if lever is too tight or too loose, remove the seat
post and adjust).
h.
The backrest on the TravelScoot can be adjusted for your comfort. Simply loosen the two bolts holding the backrest
cushion to the backrest stem. Move the cushion to the desired height and re-tighten the bolts.
Note: The above instructions are for initial setup. Many customers find it unnecessary to disassemble the seat assembly after
initial setup, and prefer to remove the whole seat assembly by releasing the clamps at the base of the yoke.
