TRAPP Master 1000 Plus, Инструкция по эксплуатации

Страница: 28 / 36

ENGLISH
26
Replacement of the nylon line
✔
The life of the nylon line depends on
the skill the operator has to avoid
contact with stones, walls, fences and
sidewalks. Frequent contact with those
obstacles cause premature wear out of
the nylon line.
✔
To substitute it, get a refill containing
the spool and the nylon line from
TRAPP technical assistance shop or
from specialized dealers.
How to remove and replace
the spool
✔
Make sure the equipment is unplugged.
✔
Turn the lawn mower/trimmer upwards.
✔
Hold the spool base (6) with one hand
and with the other remove the spool
cover (1) turning it counterclockwise (as
shown in the spool cover).
✔
After removing the spool (3), thoroughly
clean the equipment base, taking care
not to allow grass to fall in the motor
compartment.
✔
To replace the spool, pass the tip of the
nylon line (4) through hole (2), fit the
spool on cover (1), align the spool
cover on the base guide (5), press it
downward and turn it clockwise until
you hear a “click”.
Attention!
Whenever substituting the spool (refill),
keep the spring (7) to reuse it.
1
3
7
6
2
4
5
1
How to refill the spool
Should you prefer to refill the spool by
yourself:
✔
Only use a nylon line of the diameter
recommended for the model of your
equipment (1.6 mm for Master 500L,
Master 700L and 1.8 mm for Master 800
Plus, Master 1000 Plus, Master 800 and
Master 1000L).
✔
Nylon lines in a diameter other than the
specified may damage the motor and the
automatic advancing system.
✔
Remove the spool and the rest of the
nylon line.
✔
Take one end of the wire and pass it
through hole (1) as shown in the picture.
✔
Wind the wire in the direction
indicated by the arrow on the spool as
uniformly as possible. Follow the
maximum length recommended for your
equipment (6 meters for Master 500L,
Master 700L and 8 meters for Master 800
Plus, Master 1000 Plus, Master 800 and
Master 1000L).
Advance and automatic cutting of
the nylon line
1 - With the equipment running:
✔
Slightly press the spool against the
ground. The nylon line will automatically
be released. The cutting blade fixed to the
protection device will limit the amount of
wire released.