M
ENU
F
UNCTIONS
Page 36
CineMonitor
HD
3DView RF
TECHNICAL
HDMI MODE: CANON/NORMAL
Available when HDMI input is selected
Improves the video standard switching when shooting with a Canon DSLR.
GPI
Assigns functions and trigger conditions to the 4 wired GPIs.
FUNCTION #
Assigns a function to the pin # of the GPI connector (J002)
Available functions: TALLY RED, TALLY GREEN, ZOOM, HORIZON, SWITCH INPUT, FOCUS
HELPER, EXPOSURE
CONDITION #
Sets the trigger condition of the function #
Available conditions (depending on the function): NOT ACTIVE, FALLING EDGE, RISING EDGE, LOW
STATE, HIGH STATE
REMOTE CONTROL (WIRELESS)
2 remote controls can also be sent by the TitanHD Tx (transmitter) to the CineMonitorHD 3DView RF.
To use these 2 remote controls, you must set Function 1 (resp. Function 2) to GPI1 3DView RF (resp.
GPI2 3DView RF).
VOLTAGE ALARM
VOLTAGE DISPLAY: ON/OFF
FUEL READER (Anton-Bauer): ON/OFF
Displays constantly the input voltage from the power supply or the battery.
When a Logic Series Digital battery from AntonBauer is detected, the Fuel Reader also gives to the
user the remaining percentage of the battery and the time to run (see page 8).
UNIT
Toggles between Volts, Percent and Minutes (percent and and minutes only available with the
FuelReader).
ALARM
When activated the battery pictogram is displayed in red if the voltage of the power supply goes
under the threshold setting.
ALARM THRESHOLD
Sets the threshold value.
Under this value a security alert can inform the user when it is time to swap the battery on the
monitor.