7
6
Transtek Body Fat Analyzer GBF-1319-B applies BIA (Bio-impedance Analysis)
technology. A small amount of weak current flows through the human body so as to detect
the bio-impedance and estimate body fat, body water, muscle mass and CAL-MAX. The
electrical current is small and may not be felt.
This BIA technology is cheap, safe, non-invasive, toxic-free and harmless. It also
possesses the characteristics of simple operation and abundant information.
The current mentioned above is less than 1mA. However, please be aware that anyone
with an wearable or implantable medical electronic instrument, such as a pacemaker, must
avoid using this device.
The intended use of this device is for adult’s indoor use only.
Body Fat Analysis Result
Total Body Water Analysis Result
Muscle Mass Analysis Result
Calorie Analysis Result
Stone
Pound
Kilogram
Percentage
Foot
Centimeter
Age
Male
Male Athlete
Female
Female Athlete
User ID (Range from P1 to P8)
LCD Display
General Instructions
Initial Start-Up
Insert the Batteries
Open the battery door in the back of the scale.
Insert the batteries (3 x AAA) into the battery
compartment according to the polarity indications
marked inside the compartment.
* The digits “8888” will be shown on the LCD.
Close the battery door and wait until the digits “0.0”
are shown on the LCD.
CAUTION
When the symbol “Lo ” appears, the device will power off in four seconds. Then you shall replace with a
new set of batteries. Please replace all three batteries at the same time. Do NOT mix the old batteries
with the new one.
Worn batteries are hazardous waste. Do NOT dispose of them together with the household garbage.
Please refer to the local ordinances and recycling instructions regarding disposal of the worn batteries.
Less than target weight
More than target weight
Bluetooth icon
Data hasn’t been sent out
Target Weight
Difference compare with target weight
Overview