9
Zone Planning
Please read through the following 3 sections very carefully to fully
understand how to plan your zone as they are essential to make the system
work. It’s also best to have 2 people to test and do the setup.
1.
Backyard Coverage
If you want to setup your wireless fence to cover your backyard, it is best to
place the transmitter behind a window that’s facing the backyard. Assuming
your backyard is 100 feet long, you should setup your boundary at the 80 feet
mark because of signal variation reason stated above.
Initial Setup
1.
Place the transmitter behind a window that’s facing the backyard.
2.
Pair the transmitter and collar receiver.
3.
Power both the transmitter and collar receiver.
4.
Place the test light on the collar receiver’s collar contacts (shocking the air
will damage collar receiver). The collar should be flashing red every 2
seconds to show that it is active and not beep while being in close proximity
of the transmitter. The collar will go into sleep mode if it’s idled for 1 minute.
Keep shaking the collar
left and right to keep it active during the test.
5.
Set the power level on the transmitter to 100 (highest level).
Adjusting Transmitter’s Power Level
6.
Have one person carry the collar and go to the 20 feet mark before your
desired boundary, place a flag there as a reminder for you and your pet.
7.
Have the second person at the transmitter. Keep lowering the transmitter
power level slowly from 100 until the collar starts beeping.
8.
The power level of the transmitter where the collar just started beeping is the
level you should set it at for the signal to reach such distance.
Содержание KD 661C
Страница 1: ...Troubleshooting Guide ...