TranStar KD 661C, Руководство по устранению неисправностей

Страница: 15 / 21

21
Troubleshooting
The transmitter does not turn
Or
The power level display does not
turn on.

The transmitter adapter or the transmitter is defective.

Reset the transmitter by unplugging the power adapter from
the transmitter for 10 minutes.
I have an intermittent/inconsistent
signal.

Make sure the transmitter is at least 3 feet from large metal
objects or appliances and 5 feet off the ground for a stable
signal broadcast.

Make sure to set the transmitter power level to 20 or higher.
Anything lower than 20 will output signal that is too weak and
can be easily interfered.

The power level must be set high enough that your entire
house (indoor) is covered.

The receiver collar might be low on battery. Make sure the
collar is fully charged.

Reset the transmitter by unplugging the power adapter from
the transmitter for 10 minutes.
Receiver collar beeps and shocks
randomly.

There might be other nearby signal that is interfering with the
signal coming from the transmitter causing the collar to beep
at random times. Since the shocking progresses on the collar,
short signal interference will only cause the collar beep and
have a millisecond shock span if any.

The receiver collar might be low on battery. Make sure the
collar is fully charged.
Receiver collar is not beeping,
shocking or flashing

When there is no motion, the collar will go into sleep mode
and stop beeping or flashing.

Recharge the collar.

Check the power level on the transmitter, maybe the power
level is higher than what it is supposed to.
Receiver collar is beeping but the
pet is not responding to the static
shock.
Or
The electric static shock is too weak
for my dog.

Test the receiver collar with the test light.

If the test light flashes, check the fit of the receiver collar and
tighten it accordingly.

Trim your pet’s fur where the contact points touch the neck
and/or switch to the longer contact points.

Repeat training steps to reinforce training.
Receiver collar activates inside the
house/safe zone.
Or
Receiver collar starts beeping as
soon as I turn it on.

Increase the power level of the transmitter.

Re-pair the receiver and the transmitter by “Pairing.”

Relocate the transmitter to cover the dead spots.

Redo the test and find dead spots procedure.