TranStar KD 661C, Руководство по устранению неисправностей

Страница: 6 / 21

6
Pairing the Collar Receiver with the Transmitter
1.
Press and hold the ON/OFF button for 3 seconds to power on the transmitter.
2.
Quick Press the ON/OFF button again to get in pairing mode. The display will
flash "-1dP" for 10 second. While it is flashing “-1dP,” it is ready to pair.
3.
With the collar receiver on, quickly press the ON/OFF button to start pairing.
The collar receiver will show a blue light with a long beep, it means the pairing
is successful. Repeat these steps for additional collar receivers and after
each full charge.
Quick System Test
1.
Pair the collar receiver with the transmitter.
2.
Press and hold the ON/OFF button for 3 seconds to power on the transmitter.
3.
Set the power level to 10 on the transmitter.
4.
Press and hold the ON/OFF button for 3 seconds to power on the collar
receiver.
5.
Carry the collar receiver with the test light attached to the collar contacts
(metal probes) and bring it close to the transmitter. The collar receiver should
flash red light every 2 seconds that show that it is active and should not beep.
6.
Carry the collar receiver and start moving away from the transmitter. Once
the collar receiver stops receiving radio signal from the transmitter, it will start
beeping and shocking.
7.
Bring it close to the transmitter again and the collar receiver should stop
beeping and shocking.
8.
Turn off the transmitter.
9.
Again, the collar receiver will start beeping and shocking because it is not
receiving any signal.
10.
The test is successful if it performs exactly as mentioned above. If not, please
see the troubleshooting section or contact us.