TNIC
Adapter Card
18
9
Connecting Cable to TNIC Adapter Card
Connections between installed TNIC Adapter Card and hub include:
•
BNC Connector/10Base2
•
Female AUI Connector/10Base5 or transceiver
•
RJ Connector/10BaseT
•
ST TX/RX Connectors/10BaseFL
BNC Connector/10Base2 Connection
Verify that coax cables are terminated properly at both ends. (In a coax
thinnet installation, the first and last device in a daisy-chain must be
terminated with a 50 ohm terminator.)
Verify that the 10Base2 segment is grounded to “earth ground”.
50 ohm terminator
50 ohm terminator
INSTALL TNIC Driver Installation Window
The TNIC Driver Installation Window can be used to install the
following drivers:
•
Novell NetWare DOS ODI client driver
•
NDIS 2.01 driver
•
Packet driver
NOTE: Some drivers must be installed using the Network Operating
System’s OEM installation guidelines.
A driver may be installed by selecting the driver and specifying the
destination directory. Select "Install" to copy the driver to the system
hard drive.
NOTE: When INSTALL installs a device driver, sample CONFIG.NET,
AUTOEXEC.NET, and PROTOCOL.INI or NET.CFG filesare created.
The user may use these files as examples to modify the system's
CONFIG.SYS and AUTOEXEC.BAT files.
Install
Main
X
Exit
?
Help
TNIC Driver Installation Window
Card Name
Bus Type
Ethernet Address
2. Select the Device Driver from the Device Driver Selection
3. Modify the Driver Paths as needed.
4. Select Install to accept the selections and install the driver.
Instructions
*TNIC-PCI
PCI
00:00:00:00:00:00
Device Driver Selection
1. Select the TNIC Card from Card List.
Automatic Port Selection
Automatic Port Selection
Novell DOS ODI Client Driver
A:\NOVELL\WKSTN\DOSODI
C:\Netware
