Transition Networks SM24-1000SFP-AH, Руководство по установке

Страница: 51 / 76

4-7
Cable Labeling and Connection Records
4
100 Mbps Fast Ethernet Cable Lengths
10 Mbps Ethernet Cable Lengths
Cable Labeling and Connection Records
When planning a network installation, it is essential to label the opposing ends of
cables and to record where each cable is connected. Doing so will enable you to
easily locate inter-connected devices, isolate faults and change your topology
without need for unnecessary time consumption.
To best manage the physical implementations of your network, follow these
guidelines:
• Clearly label the opposing ends of each cable.
• Using your building’s floor plans, draw a map of the location of all
network-connected equipment. For each piece of equipment, identify the devices
to which it is connected.
• Note the length of each cable and the maximum cable length supported by the
switch ports.
• For ease of understanding, use a location-based key when assigning prefixes to
your cable labeling.
Table 4-7 Maximum 1000BASE-LH Gigabit Ethernet Cable Length
Fiber Size Fiber Bandwidth Maximum Cable Length Connector
9/125 micron
single-mode fiber
N/A 2 m - 40 km (7 ft - 24.9 miles) LC
Table 4-8 Maximum 1000BASE-BX10-U Gigabit Ethernet Cable Length
Fiber Size Fiber Bandwidth Maximum Cable Length Connector
9/125 micron
single-mode simplex fiber
N/A 2 m - 10 km (7 ft - 6.2 miles) LC
Table 4-9 Maximum Fast Ethernet Cable Length
Type Cable Type Max. Cable Length Connector
100BASE-TX Category 5 or better 100-ohm UTP or STP 100 m (328 ft) RJ-45
100BASE-BX 9/125 micron single-mode simplex fiber 2 m - 10 km
(7 ft - 6.2 miles)
SC
Table 4-10 Maximum Ethernet Cable Length
Type Cable Type Maximum Length Connector
100ASE-T Twisted Pair, Categories 3, 4, 5 or better
100-ohm UTP
100 m (328 ft) RJ-45