Transition Networks
SGPAT10xx-x05 PoE+ Converter User Guide
33719 Rev. C
https://www.transition.com
Page
25
of
49
4. CLI Commands
The SGPAT provides Command Line Interface (CLI) commands via the CONSOLE (RJ-45) port. Setting advanced
features via the CLI requires CABLE-CCC-06 (Cisco DB9 to RJ-45 Console Cable, Blue, 6 ft.) connected to a PC
running Terminal Emulation software (e.g., Tera Term or HyperTerminal). All of the features controlled via DIP
switch can also be controlled via CLI commands. A CLI command consists of a letter or a letter followed by a
number. The
c1
command is available to override DIP switch mode.
Connecting to the CONSOLE Port
Use a Cisco Blue cable to connect the SGPAT CONSOLE port (shown below) to the PC.
Terminal Emulator Settings
Baud Rate: 115200
Data:
8-bit
Parity:
None
Stop:
1-bit
Flow Control: None
Command Summary
The SGPAT supports these CLI commands:
a
– Active Link Pass Through {Disable:
a0
| Enable:
a1
} (see page
27
)
c
– CLI DIP Switch Override {Disable:
c0
| Enable:
c1
} (see page
28
)
d
– Dual Converter mode {Disable:
d0
| Enable:
d1
} (see page
29
)
e
– EEE Advertisement Mode {Port:1-2}{Disable:
e0
| Enable:
e1
} (see page
30
)
f
– Flow Control {PORT 1-4} {Disable:
f0
| Enable:
f1
} (see page
31
)
g
– Get PSE Status Report (see page
32
)
i
–
Port Isolation Mode {Disable:
i0
| Enable:
i1
} (see page
33
)
l
– PSE Legacy PD Detect Mode {Port 1-2} {Disable:
l0
| Enable:
l1
} (see page
34
)
m
– Complete Status Report (see page
35
)
n
– Auto Negotiation {PORT 1-2} {Forced:
n0
| Enable:
n1
}{Forced Mode 1-4} (see page
36
)
p
– ALPT PD Power Reset {Port 1-2} {Disable:
p0
| Enable:
p1
} (see page
37
)
r
– Redundant Mode {Disable:
r 0
| Enable Revert:
r1
| Enable Non-Revert:
r2
} (see page
38
)