22
CPSMC18xx-xxx PointSystem
™
chassis
po
wer suppl
y
WARNING: Do NOT connect the power supply module to the external power before installing it into
the chassis. Failure to observe this caution could result in equipment damage and/or personal injury or
death.
3.4.3 Replacing the Power Supply Fuses
Replacing the AC Fuse
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when replacing the fuse in the power supply module. Failure to
observe this caution could result in damage to, and subsequent failure of, the power
supply module.
NOTE:
Replace the fuse only with the same size and rating. Failure to observe this
caution could result in equipment damage.
1. Set the AC power supply module power switch to
“0”.
2.
Disconnect the power supply module from the external power source
.
3. From the inside edge of the power receptacle, insert a small flat blade
screwdriver into the groove on the front, inside edge of the fuse holder and
carefully pry the fuse holder from the power supply module.
4. Carefully remove the fuse from the fuse holder.
5. Install a
same size and rating
replacement fuse in the fuse holder.
6. Return the fuse holder and fuse to the installation position in the power supply
module.
Snap the fuse holder into place
.
7. Connect the power supply module to the external power source (see page 15).
24-hour Technical Support:
1-800-260-1312
-- International:
00-1-952-941-7600
I
0
Fuse Holder
Fuse
