12
CPSMC18xx-xxx PointSystem
™
Chassis
slide-in-modules
24-hour Technical Support:
1-800-260-1312
-- International:
00-1-952-941-7600
2.2.2
Installing the Management Modules
CAUTION:
Wear a grounding device and observe electrostatic discharge
precautions when installing the management module into the CPSMC18xx-xxx
chassis.
Failure to observe this caution could result in damage to, and subsequent
failure of, the management module.
NOTE:
Transition Networks recommends installing the management module into
the left-most installation slot to keep the management module cables separate from
the media converter cables.
To install a management module into the CPSMC18xx-xxx chassis:
1a.
CPSMM-200 Dual-Slot Master Management Module:
I
f
chassis face plates are covering the installation slots, remove the face plates
from the two (2) installation slots at the far-left position of the chassis.
1b.
CPSMM-120 Single-Slot Master Management Module OR
CPSMM-210 Single-Slot Expansion Management Module:
If chassis face plates are covering the installation slots, remove the face plate
from the one (1) installation slot at the far-left position of the chassis.
2. Align the management module with the chassis installation slot so that the
panel fastener screw is at the top of the module.
3. Carefully slide the management module into the installation slot, while aligning
the module’s circuit board with the installation guides.
NOTE:
Ensure that management module is firmly seated inside the chassis.
4. Push in and rotate the attached panel fastener screw clockwise to secure the
management module to the chassis.
TERM
INIT
Pwr
RESET
Conversion
Center PS
Power
In Use
1
Power
In Use
2
Panel Fastener Screw
CPSMC1800
CPSMC1800
ESD
Gnd.
Term.
Conversion
Center PS
Power
In Use
1
Power
In Use
2
MCCM10
MGMT MASTER
DB-9
RX
TX
LNK
PWR
RESET
DB-9
Panel Fastener Screw
CPSMC1800
CPSMC1800
ESD
Gnd.
Term.
