8
S4TEF10xx-10x
.
Installation
-- Continued
Install the T1/E1 Cable
1.
Locate or build ITU-compliant copper cable with straight-through RJ-48
connectors installed at both ends. (See page 13 for the proper cable
specifications for your network application.)
2.
Connect the RJ-48 connector at one end of the cable to one of the T1/E1
ports on the S4TEF10xx-10x media converter.
3.
Connect the RJ-48 connector at the other end of the cable to the T1/E1
port on the other device.
Install the RS-232 Data Cable (included)
1.
Use the enclosed RS-232 data cable with a male, DIN 6-pin connector
on one end and a DB-9 connector installed on the other end.
2.
Connect the DIN 6-pin connector to the RS-232 port on the S4TEF10xx-
10x media converter.
3.
Connect the DB-9 connector at the other end of the cable to the RS-232
port on a computer or other device that is used to collect and display
data.
Dry-Contact Relay
All four T1/E1 ports are equipped with an
RJ-48 dry-contact relay. The relay closes if
the power is lost or if any of the individual
T1/E1/E1 links are lost. The operational
rating on pins 3 and 6 are 0-30 VDC, 100
mA (maximum).
relay
3
6
RJ-48C connector
T1/E1 port
Connect the 6-pin DIN
connector to the media
converter as shown.
Connect the DB-9
connector to the
computer
RS-232 data cable (enclosed)
9
.
Installation
-- Continued
Install the Fiber Cable
1.
Locate or build ITU- compliant 100Base-FX fiber cable with male, two-
stranded TX to RX connectors installed at both ends.
2.
Connect the fiber cables to the local S4TEF10xx-10x media converter as
described:
•
Connect the male TX cable connector to the female TX port.
•
Connect the male RX cable connector to the female RX port.
3.
Connect the fiber cables to the remote S4TEF10xx-10x media converter
as described:
•
Connect the male TX cable connector to the female RX port.
•
Connect the male RX cable connector to the female TX port.
Connect the fiber cable
to the local media
converter as shown.
Connect the fiber cable
to the remote media
converter as shown
RX
TX
RX
TX
