Transcend TS-AVD1, Руководство пользователя

Страница: 44 / 51

•
Onboard FDC Controller
You can use this function to enable or disable the onboard FDC controller.
•
Onboard Serial Port 1/Port 2
Select an address and the corresponding interrupt for each of the first and second serial
ports. The choice: “3F8/IRQ4”, “2F8/IRQ3”, “3E8/IRQ4”, “2F8/IRQ3”, “Disabled” and “Auto”.
The second serial port shares resources (address and IRQ) with IrDA.
•
UART Mode Select
Choose the right type for your infrared device:
- Normal : Normal operation
- IrDA : IrDA compliant serial infrared port
- ASKIR : Amplitude shift keyed infrared port
•
UART2 Duplex Mode
Consult your IR peripheral documentation to set this field.
•
RxDx , TxD Active
Consult your IR peripheral documentation to set this field.
•
IR Transmission Delay
Consult your IR peripheral documentation to set this field.
•
Onboard Parallel Port
Select a logical LPT port name and matching address for the physical parallel (printer) port.
The choice: “378H/IRQ7”, “278H/IRQ5”, “3BCH/IRQ7” or “Disabled”.
•
Parallel Port Mode
This field allows you to set the operation mode of the parallel port. The setting “SPP”, allows
normal-speed operation but in one direction only; “EPP” allows bi-directional parallel port
operation at maximum speed; “ECP” allows the parallel port to operate in bi-directional mode
and at a speed faster than the maximum data transfer rate; “ECP+EPP” allows normal speed
operation in a two-way mode.
•
ECP Mode Use DMA
This selection is available only if you select “ECP” or “ECP+EPP” in the Parallel Port Mode.
Select either DMA Channel “1” or “3”.
40
BIOS SETUP