Neptune 6500
19
CHAPTER 6: CONFIGURATION
6.1
CONFIGURATION OVERVIEW
The indicator contains two main setup menus: The Setup (
“
F
”
) menu which configures the indicator to
your weigh platform and the User (
“
A
”
) menu which configures the serial communication port and
enables some user options. The Setup and User menus consist of several menu selections, each with its own
sub-menu of choices.
To set up the indicator, you must first enter the appropriate menu mode. Once there, four of the front panel keys
become directional navigators to move around in the menus, and one key is used to save or SET the selections.
6.2
SETUP (
“
F
”
) MENU &
“
A
”
MENU
6.2.1
ENTERING/EXITING THE SETUP MENU
1.
Power off the indicator by unplugging the power source.
2.
Remove two screws holding the small cover plate
3.
Slide the switch to the left
4.
Power on the indicator by plugging in the power source. The indicator shows
”
F
1
”
to indicate that you are in Setup Menu mode. The
“
A
”
menu follows the
“
F
”
menu. Press the right arrow key to step through all the
“
F
”
parameters to get to
the
“
A
”
menu.
5.
After completing changes in the setup menu slide the switch to its original
position, this will return the indicator to normal weighing mode. There is no need
to power down the indicator after returning the switch to the original position.
6.2.2
NAVIGATING IN THE SETUP MENU
Use the directional keys shown in Figure 6-1 to move around in the Setup Menu Chart
shown in Figure 6-3 on the following page.
1.
To move to a new
“
F
”
or
“
A
”
heading, use the 4 (left) or 5 (right) arrow key to
move right or left in the Setup Menu Chart.
2.
To move to the selection level, press the 2 (down) arrow key once. The
current saved selection is shown or the selected process will begin.
3.
To view the available selections for the current
“
F
”
or
“
A
”
heading, use the 4
(left) or 5 (right) arrow key to move through the selection field.
4.
To save a new selection, press the 3 (Set) key followed by the 1(up) arrow
key. To exit without saving, press the 1 (up) arrow key to return to the current
“
F
”
or
“
A
”
heading.
5.
Repeat Steps 1 through 4 until the Setup Menu is programmed.
Содержание Neptune-6500 Series
Страница 31: ...Neptune 6500 31...
