Command Set Summary
Remote Unit Basic System Information
Trango Broadband Wireless — User Manual TrangoLINK Rev. A for F/W Ver. 1.0
Page 9
Remote Unit Basic System Information
Logon to the RU (while it is in opmode “OFF”) and the System Information page will appear. In the CLI, type the
command
sysinfo
to receive a comprehensive snapshot of the system’s configuration info and status. Many of these
parameters can be changed by the user. A description of each of these changeable parameters, along with the related
command is shown in the table below.
?
Note: When changing settings, it is usually necessary to click the Save and Activate Button in order to update the
radio’s flash memory. If you do not, the setting will be lost the next time the radio is rebooted.
Figure 0-6 Reference Table of Basic RU System Information
REMOTE SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
Parameter
Description
Related CLI Command
Device ID
Mac ID of RU, this is used as the Remote ID
on the MU.
N/A
Opmode
Current Opmode of radio.
opmode <on
or
off>
to change the
opmode from Off to On. Note: in order
to change radio from opmode on to
opmode off, you must change the default
opmode to off and reboot the radio.
Default opmode
Determines the opmode (“on” or “off”) of the
radio after reboot/power cycle. When the
parameter is set to “on”, the radio will
progress into “on” opmode automatically after
reboot/power cycle.
set defaultopmode <on
or
off>
Example:
#>set defaultopmode on
Opmode Start
Determines the amount of time the radio will
remain in opmode OFF after reboot before
progressing to the default opmode.
set default opmode <time (secs)>
[IP]
[subnet]
[gateway]
IP, subnet, and Gateway address of radio
ipconfig [<new ip> <new subnet mask>
<new gateway>]
Example:
#>ipconfig 192.168.100.101
255.255.255.0 192.168.10.10
Tftpd
Tftpd status (on or off). Tftpd should be
turned on to import file into radio (such as
new firmware). Default is off.
tftpd on tftpd off
RF Tx Power
Current transmit power of the RU not
including antenna gain. This is controlled
during the association process.
Informational Parameter
Channel Table
Lists each of the assigned frequencies to each
channel.
freq writechannel [<ch #> freq>]…*
Channel Scan Sequence
Shows the various channels (in sequence)
which the RU will scan while search for a
MU.
freq writescan [<ch #> <h|v>…
<ch #>=1..30]
Active Channel
Shows the channel used in the current
association.
Information Parameter
Broadcast Packet Filter
This switch (switch 0) enables/disables the
blocking of Ethernet control packet except
ICMP and ARP to reduce the amount of
unnecessary overhead introduced to the
wireless link.
sw 0 [on|off]
(default is on)
(See the Command Set Reference)
MU Autoscan
This switch (switch 1) is to turn MU autoscan
on or off.
sw 1 [on|off]
(default is on)
(See the Command Set Reference)
TCP/IP for MU
This switch (switch 2) when on, allows users
at the MU side of the network to telnet or http
into the RU.
sw 2 [on|off]
(default is off)
(See the Command Set Reference)
Remarks
User definable radio information (i.e.
customer name, address of installation, and so
on). Maximum 28 characters can be stored.
remarks [remarks]
