Trango brodband TrangoLINK-10, Руководство пользователя

Страница: 11 / 29

Command Set Summary Master Unit Basic System Information
Trango Broadband Wireless — User Manual TrangoLINK Rev. A for F/W Ver. 1.0 Page 8
Figure 0-5 Reference Table of Basic MU System Information
MU SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
Parameter Description Related CLI Command
Device ID Mac ID of MU N/A
Remote ID Mac ID of the RU that is going to be associated
to the MU. N/A
Opmode Current Opmode of radio opmode <on or off> to change the opmode
from Off to On. Note: in order to change
radio from opmode on to opmode off, you
must change the default opmode to off and
reboot the radio.
Default opmode Determines the opmode (“on” or “off”) of the
radio after reboot/power cycle. When the
parameter is set to “on”, the radio will progress
into “on” opmode automatically after
reboot/power cycle. set defaultopmode <on or off>
Example:
#>set defaultopmode on
[IP]
[subnet]
[gateway] IP, subnet, and Gateway address of radio ipconfig [<new ip> <new subnet mask>
<new gateway>]
Example:
#>ipconfig 192.168.100.101
255.255.255.0 192.168.10.10
Tftpd status Tftpd status (on or off). Tftpd should be turned
on to import file into radio (such as new
firmware). Default is off.
tftpd on tftpd off
Active Channel Current RF channel and polarization (v)ertical or
(h)orizontal.
freq writescan [<ch#><v|h>]
Example:
#>freq writescan 5 v
This command will change the channel of
the MU to 5, vertical.
RF Rx Threshold Specifies the receiver sensitivity of the MU. It is
a powerful tool when the radio is in a noisy
environment. MU will block out any signal
received which is below the RF Rx threshold.
Separate settings exist for both ISM and UNII
bands.
rfrxth <ism|unii><-90|-85|-80|-75|-70|-65>
examples:
#>rfrxth ism –70
#>rfrxth unii -90
RF Tx Power Current transmit power of the MU not including
antenna gain. power <setism|senunii>
<min|max|<dBm>>
Examples:
#>power setism 10
#>power setunii 4
Channel Table Lists each of the assigned frequencies to each
channel. Note that default channels 1 – 6 are
assigned to ISM band and channels 7 – 11 are
assigned to U-NII band. All channels may be re-
assigned as desired by the user. freq writechannel [<ch#><freq>]
Example:
#>Freq writechannel 2 5785
This command will change
channel 2 to 5785 Mhz.
Broadcast Packet
Filter This switch (0) enables/disables the blocking of
Ethernet control packet except ICMP and ARP
to reduce the amount of unnecessary overhead
introduced to the wireless link sw 0 [on|off] (default is on)
(See the Command Set Reference)
Remarks User definable radio information (i.e. customer
name, address of installation, and so on).
Maximum 28 characters can be stored. remarks [remarks]
Example:
#>remarks 123 Elm Street
?
Note: If you make any changes to system settings, don’t forget to click the Save and Activate Button..