Trane XV95, Руководство пользователя

Страница: 10 / 16

10 32-5035-16
User’s Information
3. IGNITER – This unit has a special hot surface di-
rect ignition device that automatically lights the
burners. Please note that it is very fragile and
should be handled with care.
4. BURNER – Gas burners do not normally require
scheduled servicing, however, accumulation of for-
eign material may cause a yellowing flame or de-
layed ignition. Either condition indicates that a ser-
vice call is required. For best operation, burners
must be cleaned annually using brushes and
vacuum cleaner.
Turn off gas and electric power supply. To clean burn-
ers, remove top burner bracket and lift burner from
orifice.
NOTE: Be careful NOT to break igniter when removing
burners.
Clean burners with brush and/ or vacuum cleaner. Re-
assemble parts by reversal of the above procedure.
NOTE: On LP (propane) units, some light yellow tipping
of the outer mantle is normal. Inner mantle should be
bright blue. Natural gas units should not have any yel-
low tipped flames. This condition indicates that a ser-
vice call is required. For best operation, burners must
be cleaned annually using brushes and vacuum clean-
er.
NOTE: On LP (propane) units, due to variations in BTU
content and altitude, servicing may be required at
shorter intervals.
5. HEAT EXCHANGER / FLUE PIPE – These items
must be inspected for signs of corrosion, and/ or de-
terioration at the beginning of each heating season
by a qualified service technician and cleaned annu-
ally for best operation.
6. CIRCUIT PROTECTION – If blower or gas valve
fail to operate, the cause could be the circuit break-
er or a loose or blown fuse. Replace fuse or reset
circuit breaker.
FLAME
7. OPERATION – Your warm air furnace should not
be operated in a corrosive atmosphere. Paint sol-
vents, cleaning chemicals, spray propellants, and
bleaches should not be used in the vicinity of the
furnace during normal operation.
8. CONDENSATE DRAINS – If you have a cooling
coil installed with your furnace, condensate drains
should be checked and cleaned periodically to as-
sure that condensate can drain freely from coil
to drain. If condensate cannot drain freely water
damage could occur. Furnace drain should also be
checked & cleaned at the start of each heating sea-
son.
9. AIR CIRCULATION – To ensure increased com-
fort, the blower on this unit may be operated con-
tinuously for both heating and cooling. This will
result in constantly filtered air and aid in main-
taining more even temperatures by avoiding tem-
perature stratification throughout the conditioned
area. To accomplish constant air circulation, set
your comfort control fan selector to “ON”. Continu-
ous fan mode during COOLING operation may not
be appropriate in humid climates. If the indoor air
exceeds 60% relative humidity or simply feels un-
comfortably humid, it is recommended that the fan
only be used in the "AUTO" mode.”