Trane XV90i Скачать руководство пользователя страница 4

4  

32-5053-03

User’s Information

Lighting instructions.

Your furnace does not use a continuously burning pilot 
fl ame. Therefore, manually lighting your furnace is not re-
quired. Your furnace is equipped with an automatic ignition 
system. It  uses a hot surface ignition device that automati-
cally lights the burners each time the thermostat signals the 
furnace to start. 

WARNING

!

SAFETY HAZARD

DO NOT ATTEMPT TO MANUALLY LIGHT THE FURNACE.   
FAILURE TO FOLLOW THIS WARNING MAY RESULT IN 
PERSONAL INJURY, PROPERTY DAMAGE, OR DEATH. 

CAUTION

!

If the furnace is shut down during the cold weather 
months, provisions must be taken to prevent freeze-up of 
all water pipes and water receptacles.

  1.  Please read all safety information in this book before 

operating furnace.

  2.  Set thermostat to lowest setting. Turn off all electric 

power to furnace.

  3.  Remove the furnace front panel to gain access to the 

main gas valve.

  4.  Turn gas cock knob clockwise or the toggle switch 

located on the main gas valve inside the unit  to “OFF” 
position (see illustration on this page). If external gas 
cock is used, turn to “OFF” position (see illustration on 
next page). Allow 5 minutes for any gas within the unit 
to escape. LP gas being heavier than air may require 
forced ventilation. 

 

 

If you smell gas STOP! Follow the “What To Do If 
You Smell Gas” instructions on the front cover of 
this book. If you don’t smell gas, go to next step.

  5.  Turn gas cock knob counterclockwise or the toggle 

switch to “ON” marker (see illustration on this page). 
Turn the external gas cock back to the on position if 
you expect the furnace to light.

  6.  Replace the furnace front access panel.

  7.  Turn on main electrical supply and set thermostat to de-

sired setting. Combustion blower will start and ignition 
device will start to heat up. After approximately 15 sec-
onds main gas valve will open and burners will ignite.

To Start the Furnace

  8.  When thermostat is satisfi ed, main burners will 

extinguish.

  9.  Restore electrical supply panel. If main burners fail 

to ignite, lower Comfort Control setting or disconnect 
electrical supply, wait 5 minutes, raise Comfort Control 
setting above indicated temperature.

 10.  If furnace will not light, turn “OFF” all gas and elec-

tricity to unit and call servicer or gas supplier.

For complete shutdown.

Turn gas cock knob on main gas valve to “OFF” position. 
Disconnect electrical supply to unit.

Whenever your house is to be vacant, arrange to have 
someone inspect your house for proper temperature. If your 
furnace should fail to operate, damage could result, such as 
frozen water pipes.

Flame Roll-out Device.

All models are equipped with a manual resetting rollout 
switch located near the burners. In case of fl ame roll-out, 
the switch trips automatically shutting off all fl ow of gas.  
The switch must be manually reset by pressing the red 
reset button on the top of the switch.

Your furnace may have a “Knob Switch” or a “Toggle Switch” to turn the gas ON or OFF.

Gas Valve  On / Off
Toggle Switch

Gas Valve  On / Off
Toggle Switch

Содержание XV90i











Отзывы: