Trane RAUJ-C20, Инструкция по установке, эксплуатации и обслуживанию

Страница: 60 / 132

60 SS-SVX11K-EN
Figure 42. Freezestat bulbwell, temperature sensor
and well
Freezestat (6S12) Bulbwell
Bushing
Set Screw
1/2” NPT Adapter
1/4” 1-13/16” 2-13/16”
3/8”
Temperature Sensor Bulbwell
1/2” NPT
1”
Insulation
Length
3-1/4”
Insertion Length
Temperature Sensor
2-5/8”
3/8”
Freezestat
A bulbwell (located inside the remote panel) must be
installed in the leaving water piping as close to the
chiller as possible. It should be located upstream of the
temperature sensor location. The freezestat, located
within the remote panel, is equipped with a remote
sensing bulb and 20 feet of capillary tube. The remote
sensing bulb must be installed by the installing
personnel. Thermal paste is also provided inside the
remote panel and must be used when installing the
bulb into the bulb-well. Figure above illustrates the
bulbwell dimensions.
IIm mp po orrtta an ntt:: Isolate the water pumps from the system
piping to avoid vibration transmission.
Insulate all water piping. Use appropriate
pipe sealant on all threaded connections.
Final Water Piping Connections
1. Flush all water piping in the system thoroughly
before making the final connections.
N NO OT TIIC CE E
H He ea att E Ex xcch ha an ng ge err D Da am ma ag ge e!!
F Fa aiillu urre e tto o ffo ollllo ow w iin nssttrru uccttiio on nss b be ello ow w cco ou ulld d rre essu ulltt iin n
h he ea att e ex xcch ha an ng ge err d da am ma ag ge e..
IIff a an n a acciid diicc cco om mm me errcciia all ffllu ussh hiin ng g sso ollu uttiio on n iiss u usse ed d,,
b by yp pa assss tth he e E EV VP P cch hiilllle err tto o p prre ev ve en ntt d da am ma ag ge e ..
2. Clean strainer.
3. Connect the water pipe to the EVP chiller.
4. Make sure the 1/2” x 14 NPTE plug is installed.
5. Close the drain shutoff valve.
6. While filling the chiller system with solution, vent
the air from the system at the highest points.
IIn nsstta alllla attiio on n M Me ecch ha an niicca all — — E EV VP P