Table 6.
Sheet rock opening size
Unit Size
A (inches)
B (inches)
009-012
19¼
44 1/8
015-018
23¼
45¼
024-036
27 1/8
54 5/8
Installation
WSHP-SVX10H-EN
17
4. Place the door frame into the sheet rock opening. A
positive seal is critical between the back of the door frame
and the front of the cabinet. Ensure that the gasket material
seals properly.
Note:
When placing the sheet rock panel, make certain the
opening for the door is centered with the return-air
opening in the cabinet (±1/8 inches).
5. Secure the door frame to the side studs using the holes
located in the door frame and field provided screws.
Note:
If the gap between the door frame, and the side stud is
over 1/16-inch, place a shim in between the door frame
and the stud to prevent the door frame from bending/
denting.
Figure 10. Door opening
6. Place the air panel into the door opening. The gasket on
the back side of the air panel should seal around the coil
perimeter.
Note:
If return air doors or grills are not installed, field will be
required to seal gaps between cabinet and filter door.
Figure 11. Air panel gasket
7. After verifying that the air panel gasket is sealed to the coil,
secure the air panel to the door frame using the slots
located on the sides of the air panel.
Figure 12. Secure to door frame
8. Install filter.
9. Vacuum all dust and construction debris from unit after
cutting out supply/return openings.
Supply Air Ductwork
A 2" duct flange may be required to help eliminate supply air
from recirculating back into the return air, air-to-refrigerant coil
prior to discharging into the space.
Equipment containing a top discharge, ducted design: install
field ductwork to the unit providing a water tight flexible
connector at the unit. This helps prevent operating sounds
from transmitting through the ductwork. Elbows with turning
vanes or splitters are recommended to minimize air noise due
to turbulence and to help reduce static pressure.
Chassis Installation
1. Remove three 18-inch bolts on the chassis and discard.
2. Rotate the triangular metal plate to cover the bolt holes in
the chassis. Secure with two sheet metal screws.
Figure 13. Shipping bolts
(a)
(a) Not all units will include shipping bolts.
(see arrows)
3. Remove one shipping bracket (one on each side) attached
to the chassis slide rails and discard.
Note:
Remove this bracket only if the deluxe sound package
design is selected.
