Trane ACYSTAT110AA, Инструкция для владельца и по установке

Страница: 12 / 34

12
ACYSTAT-IOM-EN
Display Unit and Receiver Board
Touch Wired Control
Touch Wired Control
Name and function of buttons
1. Infrared Signal Receiver
Receives the signal from handheld remote control and
transmits the signal to indoor unit.
2. POWER button
Touch this button to start unit operation.
Touch this button again to stop unit operation.
3. Temperature Setting Button
TEMP : Touch this button to increase the set
temperature.
TEMP : Touch this button to decrease the set
temperature.
4. FAN SPEED Button
Touch this button to select fan speed.
5. MODE Button
Touch this button to select system operation mode.
In cooling only system, a mode is selected in sequence
as FAN, COOL, DRY, and back to FAN. In cooling and
heating system, a mode is selected in sequence as
FAN, COOL, DRY, HEAT, AUTO, and back to FAN.
6.2 Operation Mode
- Displays the current operation mode: FAN, COOL,
or DRY in cooling only system; FAN, COOL, DRY,
HEAT, or AUTO in cooling and heating systems
for 5 seconds when MODE button is pressed.
6.3 ECONO Mode
- Displays “ ” when ECONO mode is activated.
6.4 POWERCOOL Mode
- Displays “ ” when POWERCOOL mode is
activated.
6.5 SLEEP Mode
- Displays “ ” when SLEEP mode is activated.
6.6 Error Code
- Displays error code when an error occurs.
7. FAN Speed
- Displays the selected fan speed level: Auto, Low,
Medium, or High.
8. Standby Status
- When lit, the dot LED after the first digit of the 7
segment display indicates the standby status.
9. Compressor/Valve Status
- When lit, the dot LED after the second digit of the 7
segment display indicates the compressor/valve is on.
Operation Mode
FAN Mode
- Touch MODE button to select the operation mode.
- will be shown on the status display when FAN
mode is selected.
- Touch FAN SPEED button to select the desired fan
speed level and the display will show Low (L), Medium
(M), High (H), and Auto ( ) respectively.
Note:
• In FAN mode, the status display will show room
temperature but can not adjust set temperature,
POWERCOOL, SLEEP, and ECONO mode.
COOL Modes
- Touch MODE button to select the operation mode.
- will be shown on the status display when COOL
mode is selected.
- Touch either or button to set the desired
temperature between 15 O C to 30 O C.
6. Status Display
6.1 Room & Set Temperature
- Displays the room temperature. When FAN or
POWERCOOL mode is selected, the room
temperature will be disappeared until FAN or
POWERCOOL mode is cancelled or complete.
- Displays the set temperature (15 O C to 30 O C)
when either or button is pressed.
Indicators on Touch Wired Control