7
FIGURE A.
FIGURE B.
FIGURE C.
FIGURE D.
CLAMPING PROCEDURES
STEP #1:
WITH CLAMP IN OPEN POSITION,
REST UNIT ON RAIL BASE. BOTTOM
OF SHOES SHOULD CONTACT
TAPER ON RAIL BASE.
(SEE FIG. A)
** PERFORMANCE TIP: CLOSE
CLAMP UNTIL CLAMP PAD CON-
TACTS WEB OF RAIL PRIOR TO
STEP #2.
STEP #2:
RAISE REAR OF RAIL DRILL TO
LOCATE SHOES IN PROPER
POSITION.
(SEE FIGURE B)
STEP #3:
WHILE MAINTAINING CONTACT
BETWEEN SHOES AND RAIL,
TIGHTEN CLAMP.
(SEE FIG. C)
STEP #4:
WHEN UNIT IS FIRMLY CLAMPED,
CHECK FOR PROPER SHOE AND
PAD CONTACT ON BOTH SIDES
(SEE FIG. D)
WARNING: IMPROPER CLAMPING WILL CAUSE PREMATURE
CUTTER FAILURE
* When properly clamped to the rail there will be
a small gap between the top of the shoe and the rail.
