www.TrailFX.com
Page 2 of 7
INSTALLATION PROCEDURE
1
1. Attach both left and right side rails to the truck bed. The end of the mounting rail with the drain tube fitting
will go towards the cab of the truck, position flush to bulkhead.
2. Position the top edge of the mounting rail flush to 1/8" above the top edge of your truck bed rail.
Dodge 2002-2008 and all Colorado/Canyon
-
Stick each one of the rubber filler strips to the bed rail, adjacent to
each rail spacer (black piece with clamp written on it), prior to installing the mounting rail. Tip : Lay the cover mount-
ing rail on top of the truck bed rail, drain tube towards the cab, to help indicate position of the filler strips. The filler
strips should be mounted on the lower portion of the bed rail, Figure 1.
Dodge 2009-Current
-
Discard the rubber filler strips.
3. Using three (3) clamps per side attach the rail to the bed, position the clamps adjacent to each of the black
rail spacers. (Tip: Mount the center clamp first but do not tighten completely. This will give you the ability to
adjust the rail as the outer clamps are attached)
4. Tighten the clamps using a 1/2” socket.
2
3
Warning!
Do not overtighten the clamp assem-
bly. A torque wrench is not necessary. If preferred,
torque is apx 120 inch lbs.
Warning!
Clamps must be checked periodically
for tightness. Failure to do so could result in
damage to you or your property.
Truck Specific
Clamp Assembly
Truck Bed Rail
Rail Spacer
Cover Mounting Rail
Adjustable Position
4
Rubber Filler Strip
1/2”
