www.TrailFX.com
Page 2 of 4
Rev 101018
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS AND
WARNING ON PAGE 2 CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS
RECOMMENDED.
2.
Select (1) Inner Cross Bar and (1) Clamp Plate,
(Figure 1)
. Attach the Clamp Plate to the outside of the
upright on the Cross Bar with the included (2) 10mm x 35mm Carriage Bolts, (2) 10mm Flat Washers, (2)
10mm Lock Washers and (2) 10mm Hex Nuts. Leave hardware loose at this time.
3.
Repeat
Step 2
to assemble all (3) remaining Cross Bar inner and outer assemblies.
4.
Select (1) inner and (1) outer Cross Bar assembly. Slide (1) Inner Cross Bar into (1) Outer Cross Bar,
(Figure 2)
. Lock in place with (1) 10mm Hex Bolt,
(Figure 3)
. Do not tighten locking bolt at this time.
5.
Measure the width of the vehicle, rain gutter to rain gutter and transfer that measurement onto the
complete Cross Bar assembly.
6.
With assistance, place the Cross Bar assembly into the desired position at the front of the vehicle.
NOTE
:
Install Cross Bars with the Outer Cross Bar toward the curb or right side of the vehicle. Snug but do not
fully tighten all hardware at this time.
7.
Repeat
Step 5 & 6
to install the remaining Cross Bar assembly toward the rear of the vehicle.
8.
Select (1) Load Positioner U-Bolt and (1) 2-Hole Clamp Plate,
(Figure 4)
. Slide the U-Bolt down and over
the Outer Cross Bar. Secure the Positioner to the Cross Bar tube with the 2-Hole Lock Plate, (2) 10mm
Flat Washers, (2) 10mm Lock Washers and (2) 10mm Hex Nuts. Adjust Load Positioner location and
tighten hardware.
9.
Verify that the Cross Bar assemblies are straight and square on the vehicle and fully tighten all hardware.
10.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
(2) 10mm x 35mm
Carriage Bolts
(2) 10mm Flat Washers
(2) 10mm Lock Washer
(2) 10mm Hex Nuts
Fig 1
(Fig 2) Slide Adjustable side of
Cross Bar into Main Crossbar
