TOWBAR INSTALLATION INSTRUCTIONS
PART NUMBER KM23L
KIA CERATO BD CL2
49-75 Pacific Drive Keysborough, VIC 3173
Phone: 1800 812 017
Email:
REV A
Page 13
Issue Date: 31-05-19
41.
Remove Vehicle 20 amp fuse from location Fuse 14.
42.
Insert the supplied 20 amp fuse (1) into the Add- A-
Fuse (2) top slot and then insert the vehicle fuse (3)
into the bottom slot.
43.
Insert the Add-A-Fuse (2) to the blank fuse location in
the orientation shown (4).
44.
Connect the Add-A-Fuse (2) to the main harness (5).
Note: To maintain correct electrical operation,
ensure you insert the fuse adaptor into the allocated
slot and in the orientation shown.
45.
Connect the small T-patch harness in between the
bumper connector and vehicle connector.
46.
With the rear bumper removed, secure tail harness
and small T-patch to towbar.
47.
Route tail harness and T-patch along towbar to the
RHS.
Keep harness routing clear of all sharp edges,
moving parts and places of extreme heat.
48.
Connect the tail harness (part number 04936) 8-way
connector (1) to the trailer patch mating 8-way
connector (2).
49.
Connect the T-patch harness 3-way connector to the
trailer patch mating 3-way connector.
50.
Cut-off, crimp the tail harness GREY and GREY/BLACK
wires (3) to the trailer patch matching WHITE and
GREY/BLACK wires (4).
51.
Apply silicone grease (not supplied) (5) to waterproof
the blue connector.
