BEFORE YOU BEGIN
Remove contents from box. Remove the foam separators that protect the components
from damage during shipping. Inspect the contents of the box for scratches in the paint,
dents or kinked cables that may occurr during shipping. Because the product was 85
percent assembled and packed at the factory, there should not be any problems, even if
the box has a few scars or dents.
MAKE SURE KEY SWITCHES ARE TURNED
“ OFF” BEFORE CONDUCTING ANY
PROCEDURES.
Estimated Assembly and Set-Up Time
We recommend assembly by an adult with experience in motorbike or bicycle
mechanics.
Allow up to 30-40 minutes for assembly.
Allow up to 4-8 hours for initial charge.
Required Tools
Some tools may be supplied; however, we recommend the use of mechanic’s grade
tools. Use the supplied tools only as a last resort.
The list of tool required is as follows
·
Open end wrench 10mm / 13mm/ 17mm / 22mm
·
Allen wrench 5mm / 6mm/ 8mm
Assembly illustration and instruction
ASSEMBLY HANDLEBAR
Caution: Failure to properly adjust and tighten the bolts that affix the handlebar can
cause you to lose control and crash.
1. place the handlebar (A) in the bottom
clamp, then cover the upper clamp (B)
on the handlebar and install the 4pcs
bolt (C)
2. Place the handlebar in the upright and
vertical position, then tighten all the
bolts securely with 10mm socket
spanner.
A
：
handlebar
B
：
upper clamp
C
：
bolt M8X20 4pcs
