Figure 3
:
EOS
speakers connection
NOTE: 4 ohms and 8 ohms speakers cannot be connected to the speaker terminals at the same time!
Make sure your amplifier is properly connected to a highcurrent power receptacle.
3.
WARNING:
The
EOS
are power amplifiers. This means that they are always on at full power.
Applying an unattenuated line signal, or a signal from a preamplifier with volume control fully open will result in
full power output. This can damage your speakers or ears. Always take care that volume controls are in the
proper position (as in turned down) and that you use a controllable source.
4.
The amplifier will be fully functional after only a couple of minutes. However, as it warms up over 30
minutes, you may notice a slight improvement in the sound quality.
5.
At the end of your listening session make sure to turn the amplifier off. Leaving it on does nothing for the
sound quality and it reduces the life of the vacuum tubes.
The amplifier should always be turned on and off via its own power onoff switch.
Controls and Their Functions
11
