Figure 2
:
EOS
tube layout
Never use excessive force when inserting the tubes into their socket.
Operating Procedure
1.
Make sure that you have read the instructions before attempting to operate your unit.
2.
Attach the audio sources and speakers (refer to the picture below).
Never run the amplifier without
speakers connected since that may damage the transformers.
Speaker’s minus terminal should be
connected to the speaker terminal marked as zero (0) and positive terminal should be connected to the terminal
that corresponds to the speaker’s nominal impedance (4 or 8 ohms).The amplifier is optimized for these
impedances.Higher or lower impedances will result in higher distortion or loss of power. Do not use a speaker
with impedances lower than 2 ohms on either of the outputs.Make sure to avoid short circuiting (where you cross
+ and with the power on) at the amplifier’s speaker terminals as that will damage the amplifier.
10
