Traedgard Design Morsum, Руководство пользователя

Страница: 15 / 29

14
EN
Preparation:
1. Prepare a cross head screw driver.
2. Read this instruction manual carefully before installation and use. Keep this
instruction manual in a proper and safe place for future use in case needed.
Installation:
1. As shown in Fig. A, put Lower Tube (#8) through the hole of Base Cover(#9)
and Base (#10) making sure the end of Lower Tube with welded plate is
downward, and the extra tongue is located in the sink of the base. Fix Lower
Tube and Base together with Washer (#10) & L Screw (#11).
2. As shown in Fig. A, Install Middle Tube (#8) on top of Lower Tube. Pullout
Straight Tube (#5) upward from inside of Upper Tube (#5). Screw Outer
Fastener (#4) clockwise to lock it. Then install Upper Tube on Mid Tube (#7).
3. As shown in Fig. A, Insert Straight Tube (#3) into the hole on bottom of Control
Box (#1). Then fix them together with Screw M6*12 (#2).
4. As shown in Fig. A, Turn Outer Fastener (#4) counter-clockwise and adjust the
unit to a desired height. Then fasten it clockwise.
5. As shown in Fig. A, clip Power Supply Cord with Cord Clips (#13).
6. As shown in Fig. C, the tilting of the heater is adjustable for 25º. Adjust it to a
desired angle when necessary.
Operations:
1. Plug in the unit to a socket. Make sure the power supply is same as rated. Press
on the switch on the back of the control box. The green indicator light for
"Low" power is flashing, which means it's in standby status.
2. Switch it on by using either the control on the control box of the heater or by
using the remote controller.
3. The heater will start on the low setting, each press of the On/Power button
will cycle the heater onto the medium setting, high setting and then back to
the low setting.
4. When the heater is no longer required, switch off, using the off button on the
unit or the off button on the remote controller and unplug the unit.
Cleaning:
Unplug the unit before cleaning. It should be wiped with wet cloth. Do not use too
much water.