Tradesman DP12LW, Руководство пользователя

Страница: 14 / 22

ADJUSTMENTS
THE LASERGUIDE
Your tool is equipped a battery powered Laser Guide using
Class II laser beams. The laser beams will enable you to
preview the drill bit path on the workpiece to be drilled before
you begin your operation.
CAUTION!
AVOID DIRECT EYE CONTACT
A Laser light is radiated when the laser guide is turned on.
Avoid direct eye contact. Always un-plug the drill press from
the power source before making any adjustments.
A laser pointer is not a toy and should not come into hands of
children. Misuse of this appliance can lead to irreparable eye
injuries.
Any adjustment to increase the laser power is forbidden.
When using the laser pointer, do not point the laser beam
towards people and /or reflecting surfaces. Even a laser beam
of lower intensity may cause eye damage. Therefore, do not
look directly into the laser beam.
If the laser pointer is stored for more than three months
without use, please remove the batteries to avoid damage
from possibly leaking batteries.
The laser pointer includes no servicing components.
Never open the housing for repair or adjustments.
On units equipped with the laser attachment, repairs shall
only be carried out by the laser manufacturer or an
authorized agent.
Laser Warning label: Max output <1mW DIODE
LASER:630-670nm, Complies with 21CFR 1040.10 and
1040. 11.
ADJUSTING THE LASER LINES ( Fig. 16)
The Laser beam must always be correctly aligned with the
bit.
A. How to check the Laser-beam Alignment?
1. Adjust the table height so it is 5 inches below the bottom of
the chuck
2. Scribe a round circle (approx. 1/8”) on a piece of scrap
wood.
3. Insert a drill bit into the chuck and tighten.
4. Lower the quill and align the scribed circle with the drill bit
& fasten the wood to the table.
5. Turn on the laser and verify the laser lines (x) are centered
onto the scribed circle.
B. ALIGNING THE LASER-BEAM (Fig. 16)
To adjust the laser lines:
NOTE: Lower the chuck quill and lock it in place by
spinning the lower depth stop nut.
1.
Lower the drill press quill One inch and lock into place by
spinning the depth stop.
2. Adjust the screws (1) and bolts (2) in or out until the laser
lines (x) are centered onto the scribed circle.
3. To turn the laser on or off, press rocker switch (3).
Caution: Laser light is radiated when laser guide is turned
on.
Fig. 16
1
2
14
2
3